AQUATECH CAN165BM-100 Manuel - Sayfa 3

Su Filtrasyon Sistemleri AQUATECH CAN165BM-100 için çevrimiçi göz atın veya pdf Manuel indirin. AQUATECH CAN165BM-100 19 sayfaları. 165 series birm filter

Sayfayı Yazdır

System Specifications

Birm Filter

The birm filter contains media which removes soluble and precipitated iron without the use of chemicals. Periodic backwashing

cleans the bed.

Caution:

These water filters are not intended to be used for treating water that is microbiologically unsafe or of unknown quality without

adequate disinfection before or after the system.



Maximum Water Temperature = 110°F (43°C)



Maximum Operating Pressure = 100 PSIG

(689 kPa)



Voltage = 110 volts standard



Pipe Size = 3/4"

How The System Works

The chemical free iron filter consists of two major components which are:

1. An air injector, located between the pump and the pressure tank, adds a small amount of air to the iron-laden water

whenever the well pump runs. Refer to Figs. 1, 2 or 3 for its location.

2. A backwashing type filter containing a special media that causes the iron in the "Air Charged" water to precipitate throughout

the filter bed (rather than on the surface as in chemical oxidizing filters).

Your filter is factory set to backwash at 1:00 a.m.(can be adjusted as requested by customer) during a period of little or no water

use. The backwash cycle lasts approximately 15 minutes, after which filtered water service is restored. While backwashing is

taking place raw water automatically bypasses the filter if required. If possible, avoid using water during backwashing to prevent

iron-laden water entering your household plumbing system.

This valve is controlled with simple, user-friendly electronics displayed on a LCD screen. The main page displays the current time

and the remaining gallons in meter mode or the remaining days in calendar clock mode.



Peak flow rates are intended for intermittent use only and

are for residential application only.



At the stated service flow rates, the pressure drop through

these devices will not exceed 15 psig.



The manufacturer reserves the right to make product

improvements which may deviate from the specifications

and descriptions stated herein, without obligation to

change previously manufactured products or to note the

change.