HP StorageWorks 2/32 - SAN Switch Kurulum Talimatları Kılavuzu - Sayfa 17

Anahtar HP StorageWorks 2/32 - SAN Switch için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. HP StorageWorks 2/32 - SAN Switch 20 sayfaları. Fabric manager version 3.0.x release notes
Ayrıca HP StorageWorks 2/32 - SAN Switch için: Kullanıcı Kılavuzu (22 sayfalar), Ürün Yazılımı Sürüm Notları (14 sayfalar), Yayın Notu (48 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar), Yayın Notu (32 sayfalar), Yayın Notu (14 sayfalar), Yayın Notu (4 sayfalar)

Note:

is installed in the HP System/e rack. The plenum is not needed if the switch is installed

in an HP 9000 Series or comparable EIA rack.

Verify that the plenum (part number A7346-00001) is preinstalled on the SAN Switch

2/8 before proceeding. The plenum is required for the SAN Switch 2/8 rack mount

only, as it allows air to dissipate at the rear of the rack, preventing overheating.

If the plenum is not preinstalled on the SAN Switch 2/8, refer to the

SAN Switch 2/8 Version 3.1.x Installation Guide

instructions.

Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum

SAN Switch Rack Mount Kit Installation Instructions

b. For the SAN Switch 2/8, assemble the two inner rails (one on each side)

to the switch and plenum using the appropriate number (from

#8-32 x 3/16-inch Phillips pan-head screws as shown in

The plenum is only a required part of this installation when the SAN Switch 2/8

Figure

HP StorageWorks

for complete plenum installation

step

5) of