HP Storageworks 8100 - enterprise virtual array Değiştirme Talimatları - Sayfa 2
Anahtar HP Storageworks 8100 - enterprise virtual array için çevrimiçi göz atın veya pdf Değiştirme Talimatları indirin. HP Storageworks 8100 - enterprise virtual array 2 sayfaları. Storageworks eva virtualization adapter
Ayrıca HP Storageworks 8100 - enterprise virtual array için: Yayın Notu (13 sayfalar), Hızlı Başlangıç Talimatları (8 sayfalar), Yönetici El Kitabı (40 sayfalar), Yayın Notu (6 sayfalar)
Sayfayı Yazdır
2
Figure 1 Removing the OCP
Installing the OCP
1.
Slide the new OCP into the enclosure (1,
2.
Close the OCP until the latch engages.
3.
Install the front panel, pressing it firmly into place.
NOTE:
After installing the OCP, the controller may have to upgrade the
OCP firmware. Do not remove the OCP while this operation is in
progress. When the OCP is displaying the alternating Storage
System Name and WWID, the correct firmware has been loaded
on the OCP.
Figure 2 Installing the OCP
Verifying proper operation
After replacing the OCP, verify that it is operating properly:
1.
Check the display. It will typically display the default information
which alternates between the Storage System Name and the World
Wide Name.
2.
Press any push button. The Storage System Menu Tree should be
displayed.
Returning the failed component
Follow the return instructions provided with the new component.
3
1
0142b
Figure
2).
1
0143b
Page 2