HP XP20000/XP24000 Yapılandırma Kılavuzu - Sayfa 23

Anahtar HP XP20000/XP24000 için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. HP XP20000/XP24000 40 sayfaları. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Ayrıca HP XP20000/XP24000 için: Yayın Notu (13 sayfalar), Entegrasyon Kılavuzu (29 sayfalar), Yayın Notu (4 sayfalar), Yönetici El Kitabı (50 sayfalar), Yapılandırma Kılavuzu (42 sayfalar), Yapılandırma Kılavuzu (40 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Yapılandırma Kılavuzu (30 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Yayın Notu (5 sayfalar), Yapılandırma Kılavuzu (46 sayfalar), Yapılandırma Kılavuzu (46 sayfalar), Referans Kılavuzu (46 sayfalar), Yapılandırma Kılavuzu (40 sayfalar), Yapılandırma Kılavuzu (44 sayfalar), Yapılandırma Kılavuzu (38 sayfalar), Yapılandırma Kılavuzu (34 sayfalar), Yapılandırma Kılavuzu (30 sayfalar), Yapılandırma Kılavuzu (30 sayfalar)

Sayfayı Yazdır
HP XP20000/XP24000 Yapılandırma Kılavuzu

2 Troubleshooting

This section includes resolutions for various error conditions you may encounter.
If you are unable to resolve an error condition, ask your HP support representative for assistance.

Error conditions

Depending on your system configuration, you may be able to view error messages (R-SIMS) as follows:
•
In XP Remote Web Console (Status tab)
•
In XP Command View (Event History or Event Notification panels)
Table 5 Error conditions
Error condition
The logical devices are not recognized
by the host.
The host does not reboot properly after
hard shutdown.
Physical volumes cannot be created.
Logical volumes cannot be created.
A file system cannot be created.
Recommended action
Verify the following:
•
The READY indicator lights on the disk array are ON.
•
Fiber cables are correctly installed and firmly connected.
•
The target IDs are properly configured. The LUNs for each TID
must start at 0 and continue sequentially without skipping any
numbers.
•
The TIDs/WWNs on each bus are unique. Do not install two
devices with the same ID on the same bus. Recheck the buses for
new devices.
•
LUSE devices are not intermixed with normal LUNs on the same
port.
•
The maximum number of LUSE devices per port has not been ex-
ceeded.
•
The disk array host mode is set correctly.
•
The data in the emx_data.c file correctly maps each WWN to
a TID between 0 and 7.
If you power off the host without executing the shutdown process,
wait three minutes to allow the disk array's internal timeout process
to purge queued commands. If the host restarts while the disk array
is processing queued commands, the host may not reboot successfully.
Verify that the disk array logical devices are correctly formatted.
Verify that the volume capacity for OPEN-x volumes is not greater
than the maximum capacity allowed. See
emulations" on page 29 for capacities.
Verify that the capacity of the volume group is not less than the total
capacity of the partitioned logical volume.
Verify that logical volume name is a character-type volume.
XP Disk Array Configuration Guide for Tru64 UNIX
"Disk array supported
23