HP XP20000/XP24000 Yapılandırma Kılavuzu - Sayfa 19

Anahtar HP XP20000/XP24000 için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. HP XP20000/XP24000 38 sayfaları. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Ayrıca HP XP20000/XP24000 için: Yayın Notu (13 sayfalar), Entegrasyon Kılavuzu (29 sayfalar), Yayın Notu (4 sayfalar), Yönetici El Kitabı (50 sayfalar), Yapılandırma Kılavuzu (42 sayfalar), Yapılandırma Kılavuzu (40 sayfalar), Yapılandırma Kılavuzu (40 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Yapılandırma Kılavuzu (30 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Yayın Notu (5 sayfalar), Yapılandırma Kılavuzu (46 sayfalar), Yapılandırma Kılavuzu (46 sayfalar), Referans Kılavuzu (46 sayfalar), Yapılandırma Kılavuzu (40 sayfalar), Yapılandırma Kılavuzu (44 sayfalar), Yapılandırma Kılavuzu (34 sayfalar), Yapılandırma Kılavuzu (30 sayfalar), Yapılandırma Kılavuzu (30 sayfalar)

Configuring FC switches

OpenVMS supports Fibre Channel only in a switched fabric topology. Refer to the switch documentation

to set up the switch.

The HP service representative connects the disk array to the host by:

Verifying operational status of the disk array channel adapters, LDEVs, and paths.

Connecting the Fibre Channel cables between the disk array and the fabric switch or host.

Creating Fibre Channel zones connecting the host systems to the array ports. Refer to your switch

manufacturer's documentation for information on setting up zones.

Verifying the ready status of the disk array and peripherals.

Verify that the host recognizes the disk array devices:

Enter the show device dg command:

$ show device dg

Check the list of peripherals on the host to verify the host recognizes all disk array devices. If

any devices are missing:

If host mode option 33 is enabled, check the UUID values in the XP Remote Web Console

LUN mapping

If host mode option 33 is not enabled, check the CU:LDEV mapping

To ensure the created OpenVMS device number is correct, check the values do not conflict

with other device numbers or LUNs already created on the SAN

LUN/CU:LDEV and FCA WWN mappings on the host port

Run the $ mcr sys$etc:fibre_scan command and capture the output to scan for the

devices that OpenVMS discovers during a scan of the Fibre Channel storage devices.

Record the disk numbers and other device information. You will need the disk numbers when you

format, partition, and mount the disks.

Configure the disk array devices in the same way you would configure any new disk on the host

server. Creating scripts to configure all devices at once may save you considerable time.

Use the initialize command to format each disk array volume and write an identifying label on

it:

Example

XP Disk Array Configuration Guide: OpenVMS