Panasonic WVBP110 - MONITOR Kullanım Talimatları Kılavuzu - Sayfa 9
Dijital Kamera Panasonic WVBP110 - MONITOR için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic WVBP110 - MONITOR 14 sayfaları. Cctv cameras
Ayrıca Panasonic WVBP110 - MONITOR için: Kullanım Talimatları Kılavuzu (15 sayfalar)
Sayfayı Yazdır
Caution:
To prevent fire or shock hazard, the UL listed
wire VW-1, style 1007 should be used for the
cable for AC 24V Input Terminal.
Video Cable
1. It is recommended to use a video monitor whose
resolution is at least equal to the camera's.
2. Terminate the camera output with 75-ohm resistor
at the furthest end of its cable run.
• It is recommended to use 75-ohm coaxial cable.
• Always set the last monitor's termination switch to
75 ohms, and set the termination switches of inter¬
mediate monitors to high impedance (Hi-Z) posi¬
tion.
Monitor
Monitor
Table 1
Type of
coaxial cable
RG-59/U
(3C-2V)
RG-6U
(5C-2V)
RG-11/U
(7C-2V)
RG-15/U
(10C-2V)
Recommended
maximum
cable length
(ft)
825
1,650
1,980
2,640
(m)
250
500
600
800
Wiring precautions:
• Do not bend coaxial cable into a curve whose
radius is smaller than 10 times the cables diame¬
ter.
• Never staple the cable-not even with circular sta¬
ples. Mismatching will occur.
• Never crush or pinch the cable.
All of these will change the impedance of the
cable and cause poor picture quality.
♦ The maximum extensible coaxial cable length
between the camera and the monitor is shown in
the table 1. Since cable quality varies among man¬
ufactures, verify video quality before final installa¬
tion if maximum lengths are to be used.
-
7
-