Diamond Tech Diamond Laser 5000 Kullanım Kılavuzu - Sayfa 5

Testere Diamond Tech Diamond Laser 5000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Diamond Tech Diamond Laser 5000 8 sayfaları. Diamond laser band saw

1) To adjust the rear roller bearings, use a small hex wrench and
loosen the set screw located on the top of the blade guide block.
slide the blade guide block backward or forward to achieve proper
position (1/16" away from blade).
2) The blade should fit directly between the small square guides
(Fig.15), located on the front of the upper blade guide block. no more
than 1/16" from the blade (Fig.16). Guides help stabilize the blade to
prevent it from twisting.
3) The blade should pass through the lower blade guide block the
same as the upper set. To adjust, loosen the set screws located on
the lower blade guide mounting block and slide blade guide arm back
or forward to adjust properly (Fig.17).
NOTE: Blade guides and blade tension should be checked and
adjusted if needed after 3 hours of use. Frequent replacement
of blade guides is recommended to maintain cutting accuracy
and extend blade life.
when pushing the material through the blade while cutting, make sure
the round support bearing behind the blade does not spin. if the roller
begins to spin, back off the pressure of feeding the material until the
spinning stops. eventually you will begin to know the exact pressure
required to cut specific materials. NOTE: The support bearing should
not be used as a back stop for the blade to increase cutting time. This
constant contact will wear the blade down from the back side as well
as add pressure and friction to the blade until it snaps.
e. Upper Blade guide Height Adjustment
the position of the upper guide should be 1/4" from the top of the
material you are cutting.
To adjust height of blade guide, loosen guide bar locking knob on
back of saw and raise or lower the guide assembly (Fig. 18).
F. Straight edge / Angle guide
The band saw is designed for intricate radius cuts, however the
straight edge guide will permit moderate straight edge or fixed angle
cutting when needed. place work material against the straight edge
guide and feed the material slowly. For easy installation, place guide
in groove located on cutting table. adjust guide location by removing
the adjusting screw and moving guide to the various slots on the
table top (Fig.19).
g. Blade Tracking - Upper Wheel Tracking Adjustment
The optimal position for the blade is to track in the center of all three
blade wheels but most importantly the top wheel. if the blade is not
centered, you can adjust the hub assembly screws behind the upper
wheel. This allows for the wheel to tilt, forcing a repositioning of the
blade. You will need to remove the rear cover of the machine to expose
the 6 adjusting bolts (Fig. 20).
if the blade is coming off or riding towards the front of the top
wheel, loosen the inner Top hex Bolt and tighten the outer Top
hex Bolt, then retighten the inner Top hex Bolt.
if the blade is coming off or riding towards the back of the upper
wheel, loosen the inner Bottom hex Bolt and tighten the outer
Bottom hex Bolt, then retighten the inner Bottom hex Bolt. after
adjusting, manually turn the wheels to ensure proper blade tracking.
PAge 4
-
DL5000 INSTRUCTION MANUAL
Upper
blade
guide
Set
Screw
Locking
Knob
Inner Top
Inner Bottom
Fig.15
Fig.16
Fig.17
Fig.18
Fig.19
Outer Top
Fig.20
Outer Bottom