Panasonic PT-AE200 Kullanım Talimatları Kılavuzu - Sayfa 9
Projektör Panasonic PT-AE200 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic PT-AE200 34 sayfaları. Panasonic pt-ae200: supplementary guide
Ayrıca Panasonic PT-AE200 için: Teknik Özellikler (12 sayfalar), Garanti (1 sayfalar)
Sayfayı Yazdır
<Connector panel>
<PT-AE300U>
#
%
&
$
<PT-AE200U>
#
$
%
# AUDIO L-R input jacks
(page 18)
$ VIDEO input jack
(page 18)
This jack is used to input video
signals from a video equipment
such as a video deck.
% S2 VIDEO input connector
(page 18 and 30)
This connector is used to input
signals from an S-VIDEO-
compatible equipment such as a
video deck. The connector is
compatible with S2 and S1
signals, and projector aspect is
automatically adjusted according
to the type of signal received.
16-E
NGLISH
'
(
(
'
& DVI-D IN connector
(page 20)
This connector is used to input
DVI-D signals.
' RGB input connector
(page 20)
This connector is used to input
RGB signals from a PC.
( YP
P
(C
C
) input jacks
B
R
B
R
(page 19)
These jacks are used to input
YP
P
signals from compatible
B
R
equipment such as DVD players.
Using the remote control unit
Operating range
# Open the cover.
$ Insert the batteries so that the polarities are
correct, and then close the cover.
〇 +
〇 −
AAA batteries
(two)
NOTE:
B Do not drop the remote control unit.
B Keep the remote control unit away from liquids.
B Remove the batteries if not using the remote control unit for long periods.
B Do not use rechargeable batteries.
Operating range
If the remote control unit is held so
that it is facing directly in front of the
remote control signal receptors on
the front of the projector, the
operating range is within
approximately 7 m (23´) from the
surfaces of the receptors.
Furthermore, the remote control unit
can be operated from an angle of
±30° to the left or right and ±15°
above or below the receptors.
〇 −
〇 +
NOTE:
B If there are any obstacles in between
the remote control unit and the
receivers, the remote control unit may
not operate correctly.
B If strong light is allowed to shine onto
the remote control signal receiver,
correct remote control operation may
not be possible. Place the projector as
far away from light sources as possible.
B If facing the remote control unit
toward the screen to operate the
projector, the operating range of the
remote control unit will be limited by
the amount of light reflection loss
caused by the characteristics of the
screen used.
E
-17
NGLISH