Diamond Tech International Power Miter II Kullanım Kılavuzu - Sayfa 8

Testere Diamond Tech International Power Miter II için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Diamond Tech International Power Miter II 9 sayfaları. Chop saw

Sayfayı Yazdır

Basic Saw Operations

Removing and Installing Blade Drive Belt

WARNING; To reduce the risk of injury from unexpected

starting, unplug the saw whenever you are removing or

installing the Belt.

WARNING: Never use saw without Drive Belt Cover securely

in place

1. Unplug the saw from the outlet.

2. Remove Drive Belt Cover.

3. Loosen Motor Mount Bolts.

4. Pivot motor forward, and remove Drive Belt.

5. Replace Drive Belt, pivot motor backwards to tighten

Drive Belt.

6. Securely tighten Motor Mount Bolts.

NOTE: Drive belt tension-Drive belt should give

1/4" - 3/8" with moderate pressure.

7. Replace and securely tighten Drive Belt Cover.

Troubleshooting Guide

Motor

PROBLEM

Motor does not start.

Motor does not turn

off/on.

General

PROBLEM

PROBABLE CAUSESUGGESTED CORRECTIVE ACTION

Blade binds, jams.

Tool vibrates or shakes.

Diamond Tech International Warranty

Your Power Miter II Saw is fully guaranteed for three years. If failure occurs for any reason other

than misuse during this period, it will be corrected free of charge when product is shipped to our

distribution center. Blades and Drive Belt wear even in normal use and cannot be guaranteed.

FAX:(813) 806-2923 • E-MAIL:[email protected] • www.dticrafts.com

PROBABLE CAUSE

1. Fuse.

2. Brushes worn.

3. Other.

1. Defective switch.

1. Dull blade.

2. Improper blade.

3. Warped blade.

1. Saw blade not round.

2. Saw blade damaged.

3. Saw blade loose.

4. Other.

Diamond Tech International

5600-C Airport Blvd., Tampa, FL. 33634

HELPLINE (800) 937-9593

SUGGESTED CORRECTIVE ACTION

- 15-Amp time delay fuse, or circuit

breaker.

- Get Authorized service.

- Replace blade.

- Tighten Blade Retaining Nut

- Get Authorized service.

Drive Belt