Diamond Tech International Diamond Max Kullanım Kılavuzu - Sayfa 2

Öğütücü Diamond Tech International Diamond Max için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Diamond Tech International Diamond Max 4 sayfaları. Diamond max two-in-one grinder operations manual

Sayfayı Yazdır

Safety Precautions

1. Read the instruction manual before operating this tool.

2. ALWAYS WEAR FULL EYE PROTECTION.

3. Be sure the power switch is OFF before plugging in this tool.

4. Use only with a properly grounded electrical outlets that acceptS a three prong plug.

5. Unplug grinder before servicing. Always be sure the grinder is proper working condition before use.

6. Keep grinder clean and lubricated for safety and best performance.

7. Avoid dangerous environments. Use in a clean, well lit, and ventilated area away from flammable

vapors

8. Wear proper apparel. Remove jewelry neckties and clothing that could become caught in the

moving parts.

9. Remove all keys and wrenches before using this tool. Leaving keys and wrenched attached while

operating this tool may result in damage to the tool or operator.

10.Never leave grinder running unattended. Turn power off. Dont leave tool until it comes to a

complete stop.

Router Operating Instructions

1. Remove the packing included to protect the grinder during shipment.

2. The grinder disk must be installed before initial operation of the grinder.

To install the grinder disk use a hex wrench, loosen and remove

Grinder Head. Then, remove the grind surface, water tray, Beveling

Block and splash guard. Line up the pin hole on the bottom of the

disk with the pin on the lower support collar and lower the disk into

place. Remove the disk retaining nut and install the grinding disk.

Grease the threads of the lower support collar, then reattach the

disk retaining nut and tighten securely. Push disk down firmly to

minimize disk vibration. Installation of the disk is necessary even if no

water dripping on the motor housing.

3. Replace the water tray, grid surface, splash guard and Beveling

Block. Grease the motor shaft, then replace and tighten ensuring

that the hex screw on the bit is aligned with the flat part of the

motor shaft.

4. Fill the water reservoir about 3/4 of the way to the top. You may add

special grinding lubricant if desired.

5. Soak the sponge in water, then position it behind the water reservoir

and Grinder Head. If the sponge goes dry while grinding add

extra water directly to the sponge. NEVER GRIND DRY. Keep the slide

valve closed until ready for disk use.

6. Replace the grid cover and the grinder is ready for use. The grinder plugs directly into the Foot

switch (recommended for use) or into any outlet.

7. To setup the 1/4 bit and the Step-Up-Work Surface (Deluxe Model Only), place the 1/4 bit

directly onto the top of the shaft and tighten hex screw. The Step-Up-Work Surface has pins on

the bottom that fit into the grid cover.

8. When it is time to replace the router head or diamond disk, replace with Diamond Tech Grinder Bits

only. Other brands may not properly fit on the Diamond Max.

PLEASE NOTE: Snap 3/4 grinder head adapter into the grid surface before using the 3/4

Grinder Head.