Diamond Tools SawMaster SDT-410 Kullanıcı El Kitabı - Sayfa 6
Testere Diamond Tools SawMaster SDT-410 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Diamond Tools SawMaster SDT-410 6 sayfaları. Hand held saw
Sayfayı YazdırRemove adjusting keys or switches before turning the tool on. A wrench or a key that is left attached a rotating
part of the tool may result in personal injury.
Keep proper footing and balance at all times and do not overreach. Proper footing and balance enables better
control of the tool in unexpected situations.
Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard hat, or hearing
protection must be used for appropriate conditions.
TOOL USE AND CARE:
Use clamps or other practical way to secure and support the workpiece to a stable platform. Holding the
work by hand or against your body is unstable and may lead to loss of control.
Do not force tool. Use the correct tool for your application. The correct tool will do the job better and safer at
the rate for which it is designed.
Do not use the tool if switch does not turn on or off. Any tool that cannot be controlled with the switch is
dangerous and must be repaired.
Disconnect the plug from the power source before making any adjustments, changing accessories, or
storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally.
Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of
untrained users.
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with sharp cutting
edges are less likely to bind and are easier to control.
Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may
affect the tools operation. If damaged, have the tool serviced before using. Many accidents are caused by
poorly maintained tools.
SERVICE:
Tool service must be performed only by qualified repair personnel. Service or maintenance performed by
unqualified personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instructions in the Maintenance section
of this manual. Use of unauthorized parts or failure to follow Maintenance instructions may create a risk of electrical
SPECIFIC SAFETY RULES AND SYMBOLS:
DANGER! Keep hands away from cutting area and blade. If both hands are holding the saw, they cannot be cut
by the blade.
Keep your body positioned to either side of the saw blade, but not in line with the saw blade.
Do not reach underneath the work. The guard cannot protect you from the blade below the work.
NEVER hold the piece being cut in your hands or across your leg. It is important to support the work properly to
minimize body exposure, blade binding, or loss of control.
Always use blades with correct size and shape arbor holes. Blades that do not match the mounting hardware of
the saw will run eccentrically, causing loss of control.
Never use damaged or incorrect blade washers or bolts. The blade washers and bolt were specially designed for
your saw. for optimum performance and safety of operation.