Diamond Vantage TS400 Kullanıcı El Kitabı - Sayfa 3

Testere Diamond Vantage TS400 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Diamond Vantage TS400 20 sayfaları.

I. GENERAL SAFETY RULES FOR ALL POWER TOOLS

WARNING!

READ AND FOLLOW ALL SAFETY, OPERATING AND MAINTENANCE INSTRUCTIONS BEFORE USING THE TOOL. Failure to read

and follow these instructions could result in injury or death to you or others as well as damage to the tool and/or reduced

equipment life. Safety warnings and guidelines do not by themselves eliminate danger. They are not substitutes for proper

accident prevention procedures and good judgment. It is the operator's responsibility to use this machine under safe working

conditions and conform with federal, state and local codes or regulations pertaining to safety, air, pollution, noise etc.

KNOW YOUR POWER TOOL. Read the operator's manual carefully. Learn the saw's applications and limitations as well

as the specific potential hazards related to this tool.

KEEP GUARDS IN PLACE and in good working order.

GROUND ALL TOOLS. If tool is equipped with three-prong plug, it should be plugged into a three-hole electrical

receptacle. If an adapter is used to accommodate a two-prong receptacle, the adapter lug must be attached to a

known ground. Never remove the third prong. Check with a qualified electrician or service personnel if the grounding

instructions are not completely understood or if in doubt as to whether the tool is properly grounded.

REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are

removed from tool before turning it on.

KEEP WORK AREA CLEAN. Cluttered workplace is bound to result in higher risk of injuries. Keep area around machine

clear. DO NOT leave tools or tile pieces on the saw machine while it is in operation.

DO NOT OPERATE EQUIPMENT IN DANGEROUS OR HAZARDOUS ENVIRONMENTS. Do not use power tools in damp or wet

locations or expose to rain. Keep the work area well lighted. Do not use tool in the presence of flammable liquids or gases.

KEEP CHILDREN AWAY. All visitors and children should be kept at a safe distance from the work area. Maintain a safe

operating distance to other personnel.

MAKE SURE WORKSHOP IS CHILDPROOF with padlocks, master switches, or by removing starter keys.

KNOW HOW TO STOP THE EQUIPMENT QUICKLY IN CASE OF EMERGENCY.

10. ROTATING PARTS. Keep hands, feet, hair, and clothing away from all moving parts to prevent injury. Never operate

when the motor covers, shrouds, and/or guards are removed.

11. HOT PARTS. Engine components can become extremely hot from operation. To prevent severe burns, do not touch these

areas while the engine is running, or immediately after it is turned off. Never operate the engine with heat shields removed.

12. DO NOT FORCE A TOOL OR AN ATTACHMENT to do a job that it was not designed to do. NEVER tamper with the

governor components or settings to increase the maximum speed. Severe personal injury and damage to the engine or

equipment can result if operated at speeds above maximum.

13. SECURE WORK. Always place a work piece flat on table assembly and securely against fence. Using a clamp or a vise

to hold work piece would be helpful.

14. WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties or jewelry that may get caught in moving parts.

Non-slip footwear is recommended. Wear protective hair covering to contain long hair.

15. PERSONAL PROTECTIVE EQUIPMENT. Always wear approved respiratory, head, ear and eye protection when operating

this machine. Always use safety glasses. Wear safety glasses with side shields (must comply with ANSI Z87.1) at all

times. Everyday eyeglasses only have impact resistant lenses; they are NOT safety glasses. Use face or dust mask if

cutting operation is dusty, and ear protectors (plugs or muffs) during extended periods of operation.

• 3 • diamondvantage.com