Diamondback 500Sr Kullanıcı El Kitabı - Sayfa 3

Egzersiz Bisikleti Diamondback 500Sr için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Diamondback 500Sr 19 sayfaları. Fitness
Ayrıca Diamondback 500Sr için: Şartname Sayfası (2 sayfalar)

Sayfayı Yazdır

500Ub Upright Assembly Drawing

500Ub.Sr OM R1.indd 6-7
500Ub.Sr OM R1.indd 6-7
6

500Ub Upright Assembly Instructions

Step 1: Stabilizer Bars Assembly
1.
Place rear stabilizer bar under rear main frame body and align screw
holes.
2.
Insert two M8 x 75mm bolts into the stabilizer bar all the way
through and into the holes on the frame
3.
Secure rear stabilizer bar using an M8 nut and a curved washer on
each bolt.
4.
Repeat steps 1 – 3 to attach front stabilizer bar.
Step 2: Pedal Assembly
1.
Use a 15mm open-end wrench to fi rmly affi x the pedals to the
cranks.
2.
The left and right pedals are different and are denoted as right or left
(R or L) on the top & bottom of each pedal.
NOTE: Left pedal threads counterclockwise.
3.
Retighten cranks after approximately 10 hours of use.
Step 3: Seat Post and Saddle assembly
1.
Loosen the seat pin by turning it counter-clockwise 1-2 turns. Install seat post by slid-
ing it into seat post receptor, pulling the seat pin out until a suitable hole is found.
2.
Assemble saddle onto seat post.
3.
Tighten the affi xing nut and washer using a 17mm open-end wrench.
SADDLE ANGLE ADJUSTMENT HINT: Hold the rear of saddle in the optimum comfort
position and tighten the nut at the same time
Step 4: Console Mast Assembly
1.
Remove console mast plastic cover from the unit's body by un-snap-
ping it.
2.
Install console mast plastic cover onto console mast.
3.
Connect the main wire harness in the main frame to the main wire har-
ness in the bottom of the console mast, taking care to install correctly.
(See plug alignment marks)
4.
Install the console mast by sliding it into the console mast receptor
while gently pulling the wiring harness. This will keep the slack out of
the harness so the wires will not get pinched and short out. Insert and
tighten three M8 x 16mm bolts, one fl at washer on each side and a
curve washer on the front using a 6mm Allen wrench. Be sure not to
pinch wire harness while tightening these three screws and make sure
that the two top holes are light up with the holes on the receptor.
5.
Snap console mast plast cover into top of sidecase.
6.
Insert and tighten two M8 x 16mm bolts and fl at washers onto the two holes above the console mast
7
6/11/2008 9:54:18 AM
6/11/2008 9:54:18 AM