Panasonic RQTV0097-2P Kullanım Talimatları Kılavuzu - Sayfa 5
Stereo sistemi Panasonic RQTV0097-2P için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic RQTV0097-2P 24 sayfaları. Cd stereo system
Sayfayı Yazdır
Step 2
- Inserting batteries into the remote control
- Inserting batteries into the remote control
AA/R6/LR6
S S tep 3 3
- DEMO function
- DEMO function
Placement of speakers
Speakers are designed identically so that no left or right channel orientation is necessary.
Use only the supplied speakers.
The combination of the main unit and speakers provide the best sound. Using other speakers can damage the unit and sound
quality will be negatively affected.
Note
• Keep your speakers at least 10mm (
• These speakers do not have magnetic shielding. Do not place them near televisions, personal computers or other devices easily infl uenced
by magnetism.
• To avoid damage to the speakers, do not touch the speaker cones if you have taken the nets off.
Caution
• Use the speakers only with the recommended system. Failure to do so can damage the amplifi er and
speakers, and can cause fi re. Consult a qualifi ed service person if damage occurs or if a sudden
change in performance is apparent.
• Do not attach these speakers to walls or ceilings.
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of
time. Store in a cool, dark place.
• Do not use rechargeable type batteries.
• Mishandling of batteries in the remote control can cause electrolyte
leakage, which may cause a fi re.
Do not:
• mix old and new batteries.
• use different types of batteries at the same time.
• heat or expose to fl ame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if their covering has been peeled off.
■ Use
• Aim at the remote control sensor, avoiding obstacles, at a maximum
range of 7 m (23 feet) directly in front of the unit.
Refer to page 6 for remote control signal sensor position.
When the unit is fi rst plugged in, a demonstration of its functions may be
shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON".
Press and hold [–DEMO, 7].
The display changes each time the button is held down.
DEMO OFF
While in standby mode, select "DEMO OFF" to reduce power
consumption.
13
/
˝) away from the system for proper ventilation.
32
DEMO ON
5