Panasonic RXD27 - RADIO CASSETTE W/CD Kullanım Talimatları Kılavuzu - Sayfa 6
Stereo sistemi Panasonic RXD27 - RADIO CASSETTE W/CD için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic RXD27 - RADIO CASSETTE W/CD 12 sayfaları. Portable stereo cd system
Ayrıca Panasonic RXD27 - RADIO CASSETTE W/CD için: Kullanım Talimatları Kılavuzu (12 sayfalar)
Sayfayı Yazdır
2
1
3 4
Press [TUNER/BAND –AUTO PRESET] to select "FM" or
1
"AM".
(Unit comes on.)
2
(Omit this step if using the remote control)
If "
" is on the display, press
[TUNE MODE] to clear it.
3
Press [– /
] or [
to the desired station.
Automatic tuning
Press and hold [–/
display starts to change. A station with good reception is automati-
cally selected and the process stops.
To stop automatic tuning, press [–/
Note
Automatic tuning may stop on a frequency where there is no station
if there is interference. Press [–/
4
Adjust the volume.
To improve reception
FM: Extend the whip antenna and adjust its direction.
AM: Adjust the position of the unit.
If noise is excessive in the FM stereo mode
Press [PLAY MODE] on the remote control.
("MONO" lights up.)
Sound will be produced in monaural, but this
also reduces noise.
Press the button again to cancel. ("MONO"
goes out.)
6
RQTT0585
Listening to radio broadcasts
Normal tuning
/ +] to tune
] or [
/+] then release when the frequency
] or [
/+] again.
] and [
/+] to tune if this occurs.
Preset tuning
Preset the stations (20 FM and 12 AM) to make tuning simpler.
2
3
1
Automatic presetting
Do the following once each for FM and AM.
Preparations: Press [TUNER/BAND –AUTO PRESET] to select "FM" or
"AM".
Press and hold [TUNER/BAND –AUTO PRESET] on the main
unit until "AUTO" is displayed.
The tuner presets stations it can receive into the channels.
Manual Presetting
Remote control only
Presets one station at a time.
1
Press [PGM/CLEAR].
2
While "
" is flashing (about 10
seconds)
Press the numbered buttons to
select a channel.
To select channel 10 or higher
10] → [1] → [2]
>
e.g.12: [
=
Repeat the above to preset other stations.
The station occupying a channel is erased if another station is preset in
that channel.
To listen to preset channels
Press [TUNER/BAND –AUTO PRESET] to select "FM" or
1
"AM".
(Omit this step if using the remote control)
2
Press [TUNE MODE] to display
"
".
3
Press [– /
] or [
/ +] to select
the desired channel.
(FM:1-20, AM:1-12)
Remote control:
[
/
ALBUM](
PRESET TUNE)
or [ALBUM
/
](PRESET TUNE
2
1
RX-D29
RX-D27
Preset channel
)