DIAQUIP QFS-1200 Operatör El Kitabı - Sayfa 8

Testere DIAQUIP QFS-1200 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. DIAQUIP QFS-1200 12 sayfaları. Electric floor saw

2. CUTTING OPERATION

2.3)

Cutting operation

Aligning the machine according the cutting line. Lowering the direction indicators 11. Check that

nobody is near by the saw blade. Start the main engine according instruction under point 1.2 of

this manual. Putting on feed levers 02 and turning pushing forward knob 01 on 0 position and

then opening water supply. Adjust cutting depth indicate to zero according point 2.2.1.

With the lowering valve 04 you adjust to the desired cutting depth. Now you turn the pushing

forward knob (potentiometer) 01 an till the working feed speed has reached it maximum, so the

main motor dos not lose revolutions and that saw blade stays down in the cutting depth. Make

sure that the direction indicator 11 follows the predefined cutting line.

Its recommends to start with the first cut as a guide cut of only 5 to 6 cm depth. After this you

can easily work with cutting slices of 10 to 12cm depth an till you reach the full cutting depth.

Always drive at multiple slices in the same direction. Don't pull the machine back with an the

saw blade still cutting since it is so possible that the diamond sheet of high stroke can get.

/08