Axiris Marcel Kullanıcı Kılavuzu - Sayfa 3

Saat Axiris Marcel için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Axiris Marcel 4 sayfaları. Axiris nixie clock marcel user manual

Sayfayı Yazdır
Tubes Animation Method
option
▪ 0: No animation
▪ 1: Cycling digits every minute
▪ 2: Waving digits every minute
▪ 3: Cycling digits every 10 min.
▪ 4: Cycling digits every hour
▪ 5: Cycling digits at midnight
Cycling Digits
option
▪ 1: Left to right
▪ 2: Right to left
▪ 3: All tubes at once
▪ 4: Random
Brightness
option
▪ 1..10: Minimal to maximal
Clock's Precision
option
Press SET/ALARM to increment
the value by one.
Press ADJ/SNOOZE to decrement
the value by one.
6
Alarm Tone
option
▪ 1..9: Fast to slow pace
▪ 10: No alarm tone
Brightness of Tube Saving Mode
option
▪ 0: Off
▪ 1..10: Minimal to maximal
Start of Tube Saving Mode
option
▪ 00..23: Midnight to 23 hours
Duration of Tube Saving Mode
option
▪ 00: No saving mode
▪ 01..23: Active hours
▪ 24: Saving mode always active
User Manual
Installation
Connect the DC plug of the power supply to the DC connector on the back of the clock.
Plug the power supply into a power socket. The clock is now powered on.
Please note there's no ON/OFF switch. To power off the clock remove the power supply
from the power socket and/or disconnect the DC connector from the clock.
After you've powered on the clock, the clock will show the display mode.
When you power off the clock, the clock will remember all settings for approximately 30
minutes. All settings will be lost thereafter, meaning you'll have to set up again after
powering on the clock.

Control Panel

Turn the knob LED to control the brightness of the background lightning. The brightness
varies from no light at all to maximal intensity.
The meaning of the buttons MODE/OPTION, SET/ALARM and ADJ/SNOOZE depends
on the clock's current mode.
You can operate the buttons MODE/OPTION and SET/ALARM in two ways:
▪
Push briefly: Push the button and release immediately. This operation is called
pushing the button.
▪
Hold: Push the button for at least one second and release afterwards. This operation
is called holding the button.
User Manual
3