EasyPro ETP05N Çalıştırma Talimatları - Sayfa 2

Su Pompası EasyPro ETP05N için çevrimiçi göz atın veya pdf Çalıştırma Talimatları indirin. EasyPro ETP05N 4 sayfaları. Submersible trash pump

Installation

• Do not paint casing as overheating may occur

• Lift only by handle - not by power cable

• Do not hang water pump in water

• Install on a solid flat base in upright position

• Install proper outlet adapter for pipe or hose

• Discharge end of pipe or hose must be above water level

• Make sure that power cable plug and power outlet are away from water,

water discharge pipe or hose

Operation

• Turn off power supply or circuit breaker before connecting power cable plug

• Do not start operation with people standing near intake or outlet

• Do not operate when suspended in air

• Use pump only for circulation, transfer or removal of water or waste water

• Do not pump oil, salt water or chemical liquids

• T his pump must stay submerged entirely when operating. If used in a skimmer, the

debris net must be kept clean to ensure adequate water flow to pump. Running

pump low on water will cause overheating and premature failure which is not cov-

ered under warranty.

Safety

• U se dedicated power outlet only

• S haring the outlet with other equipment may cause over heating and fire

• I nstall in accordance with all applicable safety regulations

• Installation to be performed by qualified electrician

• Do not use without proper grounding or electrical shock may occur

Power Cord

• D o not use an extension cord

• Never submerge connecting power cable in water

• Do not tamper with the power cord

• Do not use adapter that is not grounded

• Make sure power cable does not become bent, twisted, abraded or cut

• Do not allow power cable to come in contact with heated surface

• Damaged cable may cause electric leakage, shock or fire