HTC 400 DS Kullanıcı Kılavuzu - Sayfa 27

Zemin Makinesi HTC 400 DS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HTC 400 DS 38 sayfaları.

HTC 400 DS

Note!

The dust extractor can be connected to both sockets found on

theprotective cover for the machine. If you only use one of the

sockets, thesocket not in use should be covered. Adjust the

capacity of the dustextractor to match the grinder.

4.6. Control

The machine's functions can be controlled using the control panel -

see Figure 3-3 on page 12.

During operation, the operator pushes the grinder forward over the

floor surface.

The emergency stop switch, (EM-Stop) must only be used in an

emergency.

When the switch is pressed, all electrically-operated equipment in

the machine is turned off.

Note!

Do not use the emergency stop switch to stop the machine other

than in emergencies, as it causes wear to the contactor.

2.0

Inspect the floor carefully and remove any protruding

objects, such as reinforcement rods or bolts, and any loose

debris that could get stuck in the machine.

Attach the appropriate tool to the machine.

Set the handle to the required working position.

Insert the cord.

Make sure the emergency stop switch is not activated.

Turn the On/Off switch to On ("I") to start the machine.

Turn the On/Off switch to Off ("O") to switch of the

machine.

Operation