HTC 420 VS Manuel - Sayfa 22

Zemin Makinesi HTC 420 VS için çevrimiçi göz atın veya pdf Manuel indirin. HTC 420 VS 50 sayfaları. Floor grinder | concrete floor sander
Ayrıca HTC 420 VS için: Kullanıcı Kılavuzu (46 sayfalar)

Sayfayı Yazdır
Operation
Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
1.
2.

4.4. Fitting and replacing grinding tools

Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
Warning!
After grinding, the tools will be very hot. Tip the machine back
and allow it to stand for a short while. Use protective gloves when
removing the tools.

4.4.1. Fitting grinding tools

1.
Figure 4-2 Fitting grinding tools
2.
14
Set the handle to the rear position - see Figure
4-1 on page 13.
Tip the machine backwards so that it rests against the
ground.
Slide the grinding tool diagonally from above down into
the appropriate guide slot on the tool holder. Then push the
tool fully into the guide slot, see Figure 4-2 on page 14.
Lock the grinding tool into the tool holder by giving
it a few light taps with a rubber hammer, see Figure
4-3 on page 15.
HTC 420 VS
2.0