HTC 650 HDX Kullanıcı Kılavuzu - Sayfa 36

Zemin Makinesi HTC 650 HDX için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HTC 650 HDX 48 sayfaları.
Ayrıca HTC 650 HDX için: Manuel (40 sayfalar)

Sayfayı Yazdır

Maintenance and repairs

•

Tip!

Recondition all the grinding holders at the same time.

5.5. Every month (or 100 hours)

•

5.6. Repairs

Any repairs that may be required must be carried out by a HTC

Service Centre, which has trained service personnel and uses

HTC original parts and accessories. Contact your retailer if your

machine requires servicing. For contact information, see Contact

Information at the start of the manual.

5.7. Spare parts

To ensure rapid delivery of spare parts, always specify the model,

the machine's serial number and the spare part number when

ordering. Information on the model and serial number can be found

on the machine's name plate.

Check the grinding holders. Remove the tools and run the

machine in mid air at the slowest speed. If the grinding

holders oscillate or wobble significantly, they are damaged.

Check that the upper belt is whole, by turning the large disc

in one direction or the other. If there is resistance the belt is

whole, if the disc rotates freely the belt is broken.

Tighten anything that may have vibrated loose.

Remove the grinding cover and check that it is undamaged.

Check the upper belt and replace if necessary.

Check the seals on the shafts on which the upper belt runs

and replace if necessary.

Scrape and vacuum-clean the parts shielded by the grinding

cover.

Test run and listen for any dissonance from the bearings.

Clean or, if necessary, replace the filter to the electrical

cabinet.

HTC 650 HDX

1.0