HTC 800 Classic Manuel - Sayfa 32

Zemin Makinesi HTC 800 Classic için çevrimiçi göz atın veya pdf Manuel indirin. HTC 800 Classic 36 sayfaları.

Sayfayı Yazdır

Electronic error codes

Error

Cause

code

E13

Anti-restart switch tripped

E14

Earth fault

E15

Excess voltage

E21

Excess temperature

E22

Internal processor error

E30

Internal communications error Contact HTC Service Centre.

7.3.1

Resetting the frequency converter

•

Press and hold the "RESET" button in for two seconds.

7.3.2

Checking the last error code

1. Press the "Set key" button, D001 is shown in the display.

2. Press the "arrow up" button, until D081 is shown in the display.

3. Press the "Set key" button, the error code is shown in the display.

4. Press the "arrow up" button, the frequency at the time of the error is shown in the

display.

5. Press the "arrow up" button, the motor current during the error is shown in the

display.

6. Press the "arrow up" button, the voltage of the DC bus during the error is shown

in the display.

7. Press the "arrow up" button, the operating time accumulated up to the time of the

error is shown in the display.

8. Press the "arrow up" button, the time accumulated with the voltage connected up

to the time of the error is shown in the display.

Figure 7-1. "Set key" button

For the "Set key" button, see

Action

Check the operation when starting the machine, see

Operation, page

Check the motor's cables and connections.

Mains voltage too high or disturbance in the mains supply.

Check the supply voltage, change socket.

See E08.

Contact HTC Service Centre.

Figure 7-1, page

26.

18.

HTC 800 Classic

1.0