EasyPro EC1300 Çalıştırma, Güvenlik, Garanti Talimatları - Sayfa 2

Su Filtrasyon Sistemleri EasyPro EC1300 için çevrimiçi göz atın veya pdf Çalıştırma, Güvenlik, Garanti Talimatları indirin. EasyPro EC1300 8 sayfaları. Eco-clear pressurized filters

Sayfayı Yazdır

Pressure Filter Installation

Please read all instructions carefully and keep for future reference

Safety and Electrical Connections

• Always disconnect the electrical supply before starting to handle, maintain, repair

or install any pond equipment.

• This product is not submersible, and it must be situated where it cannot fall into the water.

However, the design is weather resistant, and EasyPro Eco-Clear filters can safely be

installed outdoors.

• Direct exposure to ultraviolet light can damage eyes and skin. Do not attempt to

view the lamp when lit.

• Connect UV units only to a receptacle protected by a Ground Fault Circuit Interrupter.

(GFCI)

• Protect from the frost. In freezing climates, drain the filter and remove from the ground and

store in a warm dry place to avoid damage caused by ice.

• All electrical work must be performed by a qualified technician. Always follow the National

Electrical Code (NEC) or the Canadian Electrical Code as well as all local, state and

provincial codes. Code questions should be directed to your local electrical inspector.

Failure to follow electrical codes and OSHA safety standards may result in personal injury

or equipment damage. Failure to follow manufacturer's installation instructions may result

in electrical shock, fire hazard, personal injury or death, damaged equipment, provide

unsatisfactory performance and may void manufacturer's warranty.

Installation of the Eco-Clear Pressure Filter

1. The EC1300U comes with the UV light already installed.

2. Position pump at the furthest point from the waterfall for best circulation. Run the tubing

out of the pond to the filter. Bury or conceal the tubing as desired.

3. Solids handling Eco-Clear pumps work well with the Eco-Clear Filters.

4. Position the pressure filter anywhere around the pond. Avoid placing the filter where it

could get flooded or fall into the pond. Since the discharge is under pressure, the filter

can be located downhill from the waterfall. For units with UV lights, be sure the power

cord can reach your outlet.

5. Dig a hole big enough for the filter to sit in and at a

depth where the retaining ring is left exposed out of

the ground to allow for easy maintenance.

6. Recess the filter into the previously dug hole and

carefully backfill around the filter.

7. To maximize flow performance, use a hacksaw to

remove any smaller steps on the barb fitting than the

tubing being used.

Cut here for

3/4" tubing

Cut here for

1" tubing

Step 7