EasyPro Eco-Clear EC2600 Çalıştırma, Güvenlik, Garanti Talimatları - Sayfa 3
Su Filtrasyon Sistemleri EasyPro Eco-Clear EC2600 için çevrimiçi göz atın veya pdf Çalıştırma, Güvenlik, Garanti Talimatları indirin. EasyPro Eco-Clear EC2600 12 sayfaları. Pressurized filter with cleaning indicator and backwash feature
Sayfayı Yazdır
8. Secure the prepared barb fittings to the filter inlet
(arrow pointing in) and outlet (arrow pointing out).
Be sure to use the gasket as shown and hand tighten
nut onto filter. Do not overtighten.
9. Connect the tubing from the pump to the barbed
fitting or 1 1/2" PVC adaptor on the inlet of the filter
and secure with a clamp.
10. Connect the tubing for the waterfall to barbed fitting
or 1 1/2" PVC adaptor fitting on the outlet of the filter
and secure with a clamp.
11. Run the tubing to the waterfall and attach to a
waterfall device if applicable. Burying the tubing will
produce the most natural look for your pond.
12. If the pressure filter unit is equipped with a UV
light make sure it is properly plugged into a GFCI
protected outlet. DO NOT operate the UV light until
the pump is running.
13. For units with UV, there is a connection at the ballast
to be made. Connect the 2-pin fittings by aligning
the ends properly and firmly pushing them together.
Secure by hand tightening the nut to create a
weatherproof seal. This connection is not meant to
be submersed but is good for outdoor use.
14. Confirm the backwash valve is in the " RUN " position
and plug in the pump and UV. To switch on the UV
remove the clear top and once activated secure clear
top back on filter with thumbscrew. Observe the filter
and connections for any leaks.
15. Conceal your pressure filter and tubing with your
choice of landscaping. Fake rocks are a good option
to hide the filter.
Operation Tips
Running the filtration system continuously is the best way to keep your pond looking
its best. Once installed the filter will take a few weeks to build up sufficient nitrifying
bacteria in the system.
To maximize the filter's performance and avoid ineffectiveness or damage to the filter,
be sure to match the flow rate with the filter's specifications.
These filters are not to be used in the winter during freezing conditions. Be sure to
disconnect and drain the filter to store in a warmer location for the winter.
3
INLET
OUTLET
Steps 8, 9, 10
Step 13
Step 14