Bionaire BCH9208 Kullanım Kılavuzu - Sayfa 5
Elektrikli Isıtıcı Bionaire BCH9208 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Bionaire BCH9208 10 sayfaları. Bionaire electric heater user manual
Ayrıca Bionaire BCH9208 için: Talimat Broşürü (2 sayfalar), Talimat Broşürü (2 sayfalar)
Sayfayı Yazdır
F e AT u R e S - O P e R AT I O N S
OPeRATINg INSTRuCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Place heater on a firm, level surface.
3. Plug heater into a standard outlet. Once plugged in,
the Power Light will illuminate.
NOTe: Avoid overloading your circuit by not using other
high wattage appliances in the same outlet. At 1500
watts, this unit draws 12.5 Amps.
Mode Control
Press the Mode Button ( /Mode) on the control panel
to select your desired heat settings. Each press of the
button will cycle through the below settings and the
selected setting will appear on the LCD. To operate with
the remote control, first press the Power Button ( ) on
the remote and then press the Mode Button to cycle
through the below settings:
Figure 4
G
A
A Oscillation Button
B Mode Button
C Timer Button
D Power Light
E Up/Down Button
F LCD Display
G Remote Control
B
C
( /Mode)
HI - HIgH Heat
The heater will run continuously at 1500W.
LO - LOW Heat
The heater will run continuously at 750W.
- eco-Smart
The heater will now cycle between high (at 1500W) and
low (at 750W) heat settings to provide heat.
Thermostat Control
The next press of the Mode Button ( /Mode) will
activate the thermostat setting, and the LCD will display
"80°" as the default temperature setting.
Your heater is equipped with a digital thermostat that
allows you to set your heater to a precise comfort level
(65°F-85°F) by pressing the Up ( ) and Down ( )
Button on the control panel or remote control. The LCD
Display will show the selected temperature reading. When
the preset temperature is reached, the heater will shut off
and cool down for 10 seconds. When the room
temperature drops below the preset temperature, the
heater will automatically turn on again to maintain the
F
preset temperature level.
FrostProtect™ Setting
E
Your heater is equipped with FrostProtect™. The
heater will turn on automatically when the room
temperature drops below 40°F. To activate FrostProtect™,
D
press the Down (
"40" and the FrostProtect™ icon ( ) will appear
on the LCD Display.
- Fan Only
Press the Mode Button ( /Mode) again to activate Fan
Only setting. The heater will run at fan-only operation
without heat output.
NOTe: To shut unit off at any time, press and hold the
Mode Button ( /Mode) on the control panel for 2
seconds or press the Power Button ( ) on the remote
control to shut off the heater or keep pressing the Mode
Button ( /Mode) until the LCD Display goes OFF.
NOTe: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
Setting
TM
) Button until the LCD Display show
Setting