Bioness L300 Go Klinisyen Referans Kartı - Sayfa 2
Tıbbi Ekipman Bioness L300 Go için çevrimiçi göz atın veya pdf Klinisyen Referans Kartı indirin. Bioness L300 Go 2 sayfaları.
Ayrıca Bioness L300 Go için: Hızlı Başlangıç Kılavuzu (2 sayfalar)
Fitting the L300 Go Thigh System
Wet the Thigh cloth electrodes and snap into cuff.
1
Wipe the stimulation area with a damp, soft cloth. Place the cuff on the thigh, no less than three
2
finger widths proximal to the popliteal fossa (hamstring application) or patella (quadricep application).
Center the cuff on the midline of the thigh. Fasten the straps.
3
Program stimulation settings with the patient seated to achieve desired response.
4
If necessary, adjust stimulation settings with the patient standing.
5
1
Programming the L300 Go System
Program Stim Settings. Select desired EPG from the Stim Control Dashboard. Select
1
electrode type (Steering Electrode screen shown in image). With the patient seated, press
Test to turn on stimulation on the selected EPG. Adjust settings to achieve desired response. Press
Test to stop stimulation. Repeat step for all connected EPGs.
Test
Program Gait Settings. Press Gait Screen icon. Press
2
to enable Gait Mode. Observe patient walking and adjust settings as needed. Press
Stim Wave icon to stop stimulation.
Program Training Settings. Press
3
inclusive of excluding a specific EPG as desired. Press Training icon to turn stimulation
on all paired devices that are included in training mode. Press
stimulation.
At the end of each session unlink the system by navigating to the
4
Unlink icon. Exit the Clinician Application.
on the
Note: Press and hold the
while the button is pressed.
1
Bioness Inc
25103 Rye Canyon Loop
Valencia, CA 91355
Telephone: 800.211.9136
Email: [email protected]
Website: www.bioness.com
2
Manual Stimulation icon to activate stimulation on all paired and active EPGs
2
3
Bioness Europe B.V.
Stationsweg 41
3331 LR Zwijndrecht, The Netherlands
Telephone: +31.78.625.6088
Email: [email protected]
Website: www.bioness.com
3
Training Screen icon. Adjust training settings,
Training icon to stop
Linking Screen and pressing
4
4
Test
Stim Wave icon
For more information, visit:
www.bionessuniversity.com
Rx Only
(US only)