Dickinson 00-NEW-P9000 Kurulum ve Kullanım Kılavuzu - Sayfa 9

Kapalı Şömine Dickinson 00-NEW-P9000 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Dickinson 00-NEW-P9000 15 sayfaları. Propane fireplace/heater
Ayrıca Dickinson 00-NEW-P9000 için: Kurulum ve Kullanım Kılavuzu (12 sayfalar)

Sayfayı Yazdır

Gas Supply and Connection

Do not use high pressure propane

gas (11"w/c / 0.5psi / 27.4 mB).

If there is a propane fuel system installed a separate supply line must be supplied for the

heater. This line must be equipped with a low-pressure regulator (Dickinson Part No. 19-

151).

Connect to the 3/8" flare connector of the heater with copper or an 3/8 dia. approved

hose. During this procedure some particles may get into the fuel line. These could block

or restrict the small heater orifice.

Blow out fuel line prior to attaching to the propane supply and the heater.

Disposable Propane Bottle

It is necessary to install a pressure regulator for gas supplied from a propane bottle. For

this type of installation we recommend using a Dickinson Low Pressure Kit (Part No. 19-

150) This Kit includes a pressure regulator (11 inch W/C) and a mounting kit. The kit

must be mounted outside. A Dickinson AGA/CGA propane hose can be used to connect

this Kit to the heater. Hoses are available in 10 ft ( 3m) (Part No. 19-100-10) or 20 ft

(6m) (Part No. 19-100-20)

ATTENTION , DANGER:

1. Never connect propane/LPG heater directly to the propane/LPG supply.

This heater requires an external regulator (not supplied). Install the

external regulator between the heater and propane/LPG supply.

2. After gas hook-up and before lighting the heater, test all gas lines and

connections for leaks with a soap solution.

-8-

. The heater operates only on low pressure LPG

TYPICAL LPG ON-BOARD SYSTEM