Dickson KT6P1 Hızlı Başlangıç Kılavuzları - Sayfa 3

Ses Kaydedici Dickson KT6P1 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzları indirin. Dickson KT6P1 9 sayfaları. Remote sensing temperature recorder
Ayrıca Dickson KT6P1 için: Başlarken (7 sayfalar)

Sayfayı Yazdır

Keypad and Button Functions

On/Off

The On/Off key turns the unit on and off.

Pen Home

Pen

Home

Pen

Home

If the pen is located on the outside edge of the chart, press Pen

position. If the pen is located on the chart, press Pen

edge of the chart.

A A A A larm

larm ( ( ( ( KT6P5)

KT6P5)

larm

KT6P5)

1. 1. 1. 1. To set the alarm, make sure unit is on and press and hold the Alarm

blink red rapidly for about five seconds, then the LED will turn solid green. Release the

Alarm

Alarm button and the LED will turn solid red. At this point the display will show "On" or "Off".

Alarm

Pressing either the Adjust

to the dip switch, will toggle the alarm on or off.

2. 2. 2. 2. Pressing PEN

PEN HOME

HOME will scroll to the next alarm option. The options are as follows:

PEN

HOME

Alarm on or off

Pen 1 alarm minimum

Pen 1 alarm maximum

3. 3. 3. 3. In order to set pen alarm minimum and maximum, pressing Adjust

alarm value, and pressing Adjust

if the Adjust

Adjust- - - - Up

Adjust

Up button is held down.

Repetitively pressing the Pen

A A A A larm

larm button is pressed to exit from alarm adjust. Each press of the Pe

larm

button will store the new settings. The unit will take one minute to exit Alarm Set Mode

once the Alarm

Alarm

Alarm button is pressed.

Alarm

4. 4. 4. 4. If the alarm is triggered, the LED will show as solid red and the alarm will sound. Press the

Alarm button to silence the audible alarm.

Alarm

Alarm Relays

Alarm Relays (KT6P5)

(KT6P5)

Alarm Relays

(KT6P5)

The SPST 24V 500mA relay contacts are normally open and will close on alarm conditions when

the alarms are enabled. Relay contacts are always functional when the alarm is enabled. The

relay will close only during minimum and maximum alarm conditions. Relays will not operate

under battery only power conditions

Dickson KT6P Manual V3

Adjust

Adjust- - - - Up

Adjust

Up or Adjust

Adjust

Adjust- - - - Down

Adjust

Down buttons, located on the back of the unit next

Down

Adjust

Adjust- - - - Dow

Adjust

Down n n n will decrease the alarm value. There is acceleration

Dow

Pen

Pen Home

Home

Home button will scroll through the three options until the

Home

Pen Home

Home to move pen to recording

Pen

Home

Pen Home

Home to move the pen to the outside

Pen

Home

Alarm button. The LED will

Alarm

Adjust- - - - Up

Adjust

Up will increase the

Pen n n n Home

Home or Alarm

Home

Alarm