EPC EP-Junior Teknik Referans Kılavuzu - Sayfa 11

Kontrolör EPC EP-Junior için çevrimiçi göz atın veya pdf Teknik Referans Kılavuzu indirin. EPC EP-Junior 20 sayfaları. Dc motor speed control

Under normal circumstances, the main processor should never have to be replaced

unless a software update is required. The processor is pre-programmed from the factory,

and designed to outlast the equipment it operates. Processor replacement is only

required if:

• Processor Stops Functioning

• Internal Programming is Corrupt

• Equipment Requires a Software Update

The processor is installed in a 28-pin socket (8-pin for the NEV controller), and is easily

removable. When replacing the processor, BE SURE to install it with the notch (or dot)

facing the same direction. These indicators are visible in the pictures below.

AT-MEGA328 (most common)

Processor, Found in most EPjr

and EP-1000 Controllers

Software updates are available from EPC Corporation, if needed. More information on

software updates is available online at www.EP-1000.com

PROCESSOR REPLACEMENT

AT-Tiny85 Processor,

Found in NEV Controllers