Alpha Marine Systems Alpha 3000 Kurulum ve Kullanım Kılavuzu - Sayfa 15
Otopilot Sistemi Alpha Marine Systems Alpha 3000 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Alpha Marine Systems Alpha 3000 16 sayfaları.
Sayfayı Yazdır
SECTION 4.0 MAINTINENCE
Every component has been thoroughly tested and component materials have been chosen
for inherent resistance to the marine environment. The electronic units should require no
maintenance in normal service. If the occasion should arise it is suggested that they be
returned to the factory for service. If this is not practical, any competent marine
electronics technician should be able to effect repairs.
Every effort has been made in the design of this unit to utilize commercially available
components. However, whenever possible replacement parts should be obtained from the
factory to ensure optimum performance. Some system components are available only
from Alpha Marine Systems because of their custom nature.
The mechanical drive unit has seals. However, the extending and retracting nature of the
drive piston causes the internal volume of the unit to change, making a total seal
impractical. Therefore, to prevent water intrusion, none of the drive unit parts should be
submerged in bilge accumulations.
Your autopilot has been designed to be basically maintenance free. However, occasional
lubrication of the Drive Link, Latch, Swivel and Ball Joint is recommended. Inspection
and adjustment of latch for proper engagement and disengagement is also recommended.
Wherever the unit is mounted, it should be kept clean and all bolts checked for tightness.
The Compass Unit requires no maintenance other than to keep it clean and give it the
care you would any precision compass assembly. The compass is liquid-filled and sealed
and contains no user serviceable parts, therefore, if the compass should need repair it
must be returned to the factory for this work.
The Control Unit uses sealed controls for protection from the salt and moisture
environment, therefore, it also must not be opened. If the unit needs repair, it is
recommended that it be returned to the factory. If this is impractical, the entire unit
should be taken to a competent marine electronics technician.
If you should experience difficulty, make sure the unit is wired according to the
information contained in the Installation Sections.
Occasionally rodents get aboard a boat. These creatures seem to have an appetite for
electrical insulation and of course they frequent the less visible areas. If unexplained
performance problems arise, particularly of an intermittent nature, all wiring should be
carefully examined for this type of damage and chafe from vibration, as well as for loose
connection.
A trouble shooting guide is on the following page. The purpose is to isolate what unit is
causing the problem and is not intended as a repair manual. Consult the factory or
authorized
Dealers for service.
AMS