Alpha Professional Tools VSP-340 Kullanım Kılavuzu - Sayfa 3

Sander Alpha Professional Tools VSP-340 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Alpha Professional Tools VSP-340 20 sayfaları. Variable speed wet polisher

Sayfayı Yazdır

SPECIFICATIONS

7.0A

120 Volts

3.5A

230 Volts

INTRODUCTION

Thank you for purchasing the Alpha

VSP-340 Variable Speed Wet Polisher. Please read this

instruction manual thoroughly to ensure safe and correct

use of the polisher. Keep this manual in a place where

operators can access it easily whenever necessary.

ABOUT THE SYMBOLS

According to the hazard level, all safety notes in this

manual are classified into "DANGER", "WARNING"

and "CAUTION".

DANGER! - Death or serious personal injury is

imminent when handling this polisher incorrectly.

WARNING! - There is a possibility of death or serious

personal injury when handling this polisher incorrectly.

CAUTION! - There is a possibility of personal injury or

property damage when handling this polisher incorrectly.

NOTE: In some situations, failure to observe

WARNING notes could result in death or serious

personal injury. Be sure to read and observe the

safety notes to ensure safety and correct use of the

electric wet/dry stone cutter

SAFETY INSTRUCTIONS FOR POWER

TOOLS

1. Know Your Power Tool. Read owner's

manual carefully. Learn its applications and limita-

tions as well as specific potential hazards particular

to this tool.

2. Keep Work Area Clean. Cluttered areas and

benches invite accidents.

3. Avoid Dangerous Environments. Keep

work areas as dry as possible. Do not use tool in

presence of flammable liquids or gases. Keep the

area well lit.

4. Keep Children and Visitors Away. All

visitors should be kept a safe distance from the work

area. Keep out of reach of children.

Single-

700~2500

phase AC,

RPM

50/60Hz

VSP-320 /

800W

A(120V)

C(230V)

5. Don't Force Tool. It will do the job better and

safer at the rate for which it was designed.

6. Wear Proper Apparel. Do not wear loose cloth-

ing or jewelry as it can get caught in moving parts.

Rubber gloves and insulated non-skid footwear

are recommended. Wear protective covering to

contain long hair.

7. Wear Proper Eye Protection. All users and

bystanders must always wear proper personal eye

protection which conform with ANSI/ISEA Z87.1

(CAN/CSA Z94.3). Also, use a face or dust mask

if operation is dusty. Always wear certified safety

equipment.

8. Wear Proper Ear Protection. All users and

bystanders must wear proper personal ear protection

which conforms with ANSI S12.6 (S3.19) hearing

protection.

9. Wear Proper Respiratory Protection. All

users and bystanders must wear proper personal

respiratory protection. Always use NIOSH/OSHA

approved respiratory protection appropriate for the

dust exposure.

WARNING! Some dust created by power

sanding, sawing, grinding, drilling, polishing and

other construction activities contains chemicals

known to the State of California to cause cancer,

birth defects, or other reproductive harm.

Some examples of these chemicals are:

• Lead from lead-based paints

• Crystalline silica from bricks, cement and other

masonry products, and

• Arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depend-

ing on how often you do this type of work. To

7.3 lbs

(VSP-320)

3.3 kgs

(100mm)

(VSP-340)

Spindle

English

5/8"-11

Spindle

M14-2