Accuglide Ez-tilt Montaj Talimatları Kılavuzu - Sayfa 6

İç Mekan Mobilyaları Accuglide Ez-tilt için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Accuglide Ez-tilt 7 sayfaları. Fabrication table

Sayfayı Yazdır

5) When you're ready to tilt the table back to the upright position, pull the lock pin and rotate the

Flip Down Leg up until the pin re-locks the leg in the horizontal position.

6) IMPORTANT NOTE: Before tilting the table, make sure to secure the crank handle with the

chain lanyard. DO NOT TILT THE TABLE WITH THE HANDLE LOOSE. Doing so will damage the

handle and prevent the table from reaching its full upright position.

IMPORTANT SAFETY NOTE:

(pictured right) is detected, discontinue use of the table and contact

AccuGlide Saws immediately. Never load or operate the table without

the latch fully operational. After tilting the table to the upright position

and the lock pin has snapped in place, always confirm the table is

solidly locked in position by giving the handle a quick pull.

Fig: A

Safety Strap Arm and Slab Keepers: After tilting the table to the horizontal position the Safety

Strap Arm can be flipped out of the way to keep the table clear for cutting and unloading. Pull the

lock knob and rotate the arm counterclockwise until it snaps into its horizontal position. The Safety

Strap can be stored out of the way by clipping the strap end onto the eye bolt on the right front cor-

ner of the table (Fig. B). CAUTION: Make sure to flip the Safety Strap Arm to the up position be-

fore loading a slab. NEVER REACH UNDER A SLAB TO FLIP THE SAFETY STRAP ARM TO THE

UP POSITION. The Slab Keepers (Fig. C) can also be removed while cutting on the table top. Keep

the tube that the Slab Keepers insert into, clean and without obstructions. CAUTION: The Slab

Keepers must be fully inserted into the receiver tub before loading the slab.

Secure handle before tilting

If any malfunction in the Vertical Latch

Fig: B

Fig: C