EPHESUS Stadium Kurulum Talimatları Kılavuzu - Sayfa 5

DJ Ekipmanları EPHESUS Stadium için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. EPHESUS Stadium 16 sayfaları. Stadium series

Sayfayı Yazdır
An impact driver may be used on mounting hardware while the power is off, but NEVER use any power tools on the
fixture while the power is on. The vibration caused by power tools may damage the fixture. FAILURE TO FOLLOW
THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND FAILURE.
There are two different ways to mount the Stadium fixture – Standard and Inverted. Standard mounting is when the luminaire
sits on top of the mounting structure, and Inverted is when the luminaire hangs from underneath the structure.
Standard Mounting
This is the most common mounting. The luminaire sits on top of mounting structure.
1.
Refer to the photometrics or project Installation Drawings to determine luminaire installation locations and lens type.
2.
For each fixture location, install a luminaire that has the correct lens type. Unless otherwise noted, fixtures that share
the same lens type are identical.
3.
Set luminaire in place and install bolt, washers, and nut to securely fasten the fixture mounting bracket to the mounting
structure. Tighten hardware hand tight so that fixture is secure but do not fully torque hardware until aiming is complete.
4.
Remove the clear protective film from the front of the lenses, if present.
Figure 2. Standard Mounting
N
otee:
Example mounting structure shown for illustration purposes only.
Inverted Mounting
The luminaire hangs from underneath mounting structure.
When using inverted mounting, flip the mounting bracket so that the luminaire stays upright. NEVER install the
luminaire upside down. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND
FAILURE.
1.
To install the luminaire underneath a mounting structure, the fixture mounting bracket must first be inverted.
Remove Hex bolt and set screw on each side of the fixture.
●
●
Remove Fixture Mounting bracket and flip it so that the bracket faces up.
●
●
Reinstall hex bolts and set screws on each side of the fixture.
●
●
Hex Bolt
Mounting
Structure
Flat Washer
Installation Instructions - Stadium Series
WARNING
Hex Nut
WARNING
EATON
IB528002EN
Installation instructions rev 20171011
5