DieHard 200.71491 Kullanıcı El Kitabı - Sayfa 10
İnvertör DieHard 200.71491 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. DieHard 200.71491 12 sayfaları. Converts 12v dc power to 110v ac household electrical power
Sayfayı Yazdır
PRObLEM: Low or No Output Voltage
Reason/Solution
1. Poor contact at terminals.
Unplug and reinsert Power Inverter 140.
2. Equipment being operated is drawing too much
power.
Use a higher capacity inverter or do not use the
device.
3. Inverter is too hot (thermal shut down).
Allow inverter to cool. Check for adequate ventila-
tion. Reduced the load on the inverter to rated
continuous power output.
4. fuse blows
A blown fuse is usually caused by reverse polarity
or a short circuit within the device being operated.
To replace:
• Disconnect the device immediately.
• Find the source of the problem, and repair it.
• Install a new 15-amp fuse. Do not tighten the fuse
cap too far; finger tight is sufficient.
NOTE: Installing a fuse higher than 15-amps may
cause damage to the inverter.
5. Inverter may be defective.
Call 1-800-SEARS-64 (1-800-732-7764) for trouble-
shooting assistance, or return it to any Sears store
or other DieHard outlet in the United States for a
free replacement.
TROUbLESHOOTINg
10