Olympus Camedia C-21 Tamamlayıcı Kılavuz - Sayfa 30

Dijital Kamera Olympus Camedia C-21 için çevrimiçi göz atın veya pdf Tamamlayıcı Kılavuz indirin. Olympus Camedia C-21 47 sayfaları. Using a personal computer

Sayfayı Yazdır
E

TROUBLESHOOTING

Operating Problems

The camera does not work.
The power is OFF.
- Open the lens barrier to turn on the power. (p. 32)
The batteries are loaded incorrectly.
- Reload the batteries correctly. (p. 27)
The batteries are exhausted.
- Replace the batteries with new ones. (p. 27)
The batteries are temporarily unable to function.
- Keep the batteries warm while using the camera.
No picture is taken when the Shutter release
button is pressed.
The flash has not finished charging or the previous
picture is being written into the card.
- Remove your finger from the Shutter release button and
wait until the Green lamp stops blinking. (p. 58/38)
There is no card in the camera or there is a problem with
the card.
- See the Error code chart. (p. 134)
The flash does not fire.
The flash mode was set to the Off mode.
- Check the flash mode before shooting. (p. 58)
The subject is lighted.
- Set the flash to Fill-In mode. (p. 61)
The pictures already taken do not appear
on the LCD monitor.
The camera is in the Record mode.
- Close the lens barrier and depress the LCD monitor
ON/OFF button to turn on the LCD monitor. (p. 45)
There is no picture in the card.
- NO PICTURE appears on the LCD monitor. (p. 45)
There is a problem with the card.
- See the Error code chart. (p. 134)
128
E
The LCD monitor is hard to read.
The brightness may be incorrectly set.
- Adjust the brightness. (p. 123)
When the camera is connected to a computer,
an error message appears while data is being
transferred to the computer.
The cable is not plugged in correctly.
- Connect the cable correctly. (p. 102)
The power is OFF.
- Open the lens barrier to turn on the power. (p. 32)
The batteries are exhausted.
- Replace the batteries with new ones (p. 27) or use the
optional AC adapter (p. 28).
The serial port is not selected correctly.
- Use the operating system software to make sure the serial
port is selected correctly.
There is no available serial port.
- Make one available by following the computer's instructions.

Problems with Images

The picture is out of focus.
The camera moved when the shutter button was pressed.
- Hold the camera correctly, and press the shutter button.
(p. 36/37)
The viewfinder's autofocus mark was not positioned on
the subject.
- Position the autofocus frame on the subject, or use the
focus lock. (p. 41)
The lens is dirty.
- Clean the lens with a soft dry cloth.
The mode was not selected correctly.
- Shoot with the Macro mode when the subject is within the
range of 6" ~ 24". For further distances, shoot with the
Standard mode. (p. 44/63)
The Shutter release button was pressed right in front of
the camera in the Selftimer mode.
- Press the Shutter release button while looking into the
viewfinder, not while standing in front of the camera.
(p. 72)
The Preset focus was used with the wrong focal range.
- Use the right Preset focus for the distance. (p. 64)