AXITEC AC-285M/60V Kurulum Kılavuzu - Sayfa 6
İnvertör AXITEC AC-285M/60V için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. AXITEC AC-285M/60V 17 sayfaları.
3.6.
General Installation
Module mounting must use the pre-drilled mounting holes in the frame. Mounting ways: Using 8
screws and 8 screw nut to respectively fix the 8 mounting holes, see the figure below.
▪
Do not lift the module by grasping the module's junction box or electrical leads.
▪
Do not stand or step on module.
▪
Do not drop module or allow objects to fall on module.
▪
To avoid glass breakage, do not place any heavy objects on the module.
▪
Do not set the module down hard on any surface.
▪
Inappropriate transport and installation may break the glass of the module.
Installing Methods
3.7.
3.7.1. Modules installed with mounting holes (14*9). Modules should be
3.7.2. Modules installed with mounting holes (10*6.5) Modules should be
3.7.3. Modules installed with clamping, Modules should be bolted to the
3.7.4. the clamps must not make contact with the front glass or deform
bolted with M8 bolt to the support structures through mounting
holes located in the frame back flanges. See the table as follow. The
torque should be 12.5N·m-18N·m to tighten the bolt.
bolted with M6 bolt to the support structures through mounting
holes located in the frame back flanges. See the table as follow. The
torque should be 12.5N·m-18N·m to tighten the bolt.
support structures rail by metal clamps. It is recommended to use
clamps under the following condition or approved by system
installation Clamps materials: Aluminum Alloy Bolt torque
requirments:12.5N·m-18N·m
frame in any way. Materials and sizes of Bolts, screw nuts, flat
washers, spring washers that refer to mounting are as follows:
(Stainless steel (SS)) Bolt: M8 SS, Flat washer SS:Φ16-Φ8.4 H1.6 SS
Spring washer: Φ12.6-Φ8.4 H4.7 SS
Installation Manual
Page 5 / 16