Olympus IX81-ZDC2 Talimatlar Kılavuzu - Sayfa 2

Mikroskop Olympus IX81-ZDC2 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Olympus IX81-ZDC2 16 sayfaları. Focus drift compensating microscope

Olympus IX81-ZDC2 Talimatlar Kılavuzu
Compliance
This device complies with the requirements of both directive 2004/108/EC concerning electromagnetic
compatibility and directive 2006/95/EC concerning low voltage. The CE marking indicates compliance
with the above directives.
IEC61326-1 defines two categories according to the location for use.
Class A: Equipment suitable for use in establishments other than domestic, and those directly con-
nected to a low voltage power supply network which supplies buildings used for domestic
purposes.
Class B: Equipment for use in domestic establishments, and in establishments directly connected to a
low voltage power supply network which supplies buildings used for domestic purposes.
This system is applied Class A. Some interference may occur if this system is used in domestic location.
In accordance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment,
this symbol indicates that the product must not be disposed of as unsorted municipal waste, but
should be collected separately.
Refer to your local Olympus distributor in EU for return and/or collection systems available in your
country.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.