Olympus PFL-01 Kullanım Kılavuzu - Sayfa 28

Kamera Aksesuarları Olympus PFL-01 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Olympus PFL-01 39 sayfaları. Underwater case for the electronic flash fl-20

Sayfayı Yazdır

CAUTION

: • When a mechanical pencil or a similar other sharp

object is used to remove the O-ring or to clean the

inside of the O-ring groove, the Case and the O-ring

may be damaged and water leakage may be caused.

• When the O-ring is checked with the fingertips, take

care not to stretch the O-ring.

• Never use alcohol, thinner, benzene or similar solvents

or chemicals detergents to clean the O-ring. When such

chemicals are used, it is likely that the O-ring will be

damaged or that its deterioration will be accelerated.

Install the O-ring

Confirm that no foreign matter is attached, apply a thin coat of the

accessory grease to the O-ring, and fit the O-ring into the groove. At

this time, confirm that the O-ring does not stick out from the groove.

❈This sections explains how to apply lubricant to the camera case.

Use the same procedure for the flash case.

How to Apply Grease to the O-ring

Apply the

specified grease

Spread the grease

over the O-ring.

Check that there

is no damage or

irregularities on

the O-ring.

Apply the grease

to the O-ring

contact surface.

Make sure there is no dirt on your

fingers or on the O-ring; then

squeeze about 5 mm of grease

onto your fingertip.

Using two fingers and a thumb,

spread the grease over the O-ring

while rubbing it in. Use caution not to

squeeze or pull the O-ring too hard.

Once the grease has permeated

throughout the O-ring, check it for damage

or irregularities (both visually and by

touch). If you notice any abnormalities,

replace the O-ring with a new one.

Use any residual grease on your

fingertips to clean and lubricate the O-

ring contact surface on the front lid.

E-27