Olympus PT-E06 Kullanım Kılavuzu - Sayfa 11

Kamera Aksesuarları Olympus PT-E06 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Olympus PT-E06 30 sayfaları. Underwater camera case

2. Advance check of the Case

This Case has been the subject of thorough quality control for the parts during the manufacturing

process and thorough function inspections during the assembly. In addition, a water pressure test is

performed with a water pressure tester for all products to confirm that the performance conforms to the

specifications.

However, depending on the carrying and storage conditions, the maintenance status, etc., the

waterproof function may be damaged.

Before using, always perform the following advance checks.

Check the waterproof parts of the Case

Check the waterproof parts of the Case as described below.

1 Ensure that the Case's O-rings are firmly attached and secured with the slide lock and the open/close

dial.

2 Ensure that the separately available Waterproof Port is installed correctly, and that the Waterproof

Port is attached firmly to the O-ring between the Waterproof Port and Case.

3 Ensure that the O-ring of the TTL connector is attached firmly and that the cap is screwed into the

connector without loosening.

Advance check

1 Before loading the digital camera in the Case, immerse the empty Case to confirm that there is no

water leakage. When it is difficult, water leakage can be checked by referring "Water Leakage Test"

(P.19).

2 Main causes of water leakage are as follows.

• Forgetting to install the O-ring

• Part of an O-ring or an entire O-ring is outside the specified groove.

• O-ring damage, cracks, deterioration or deformation

• Sand, fibers, hair or other foreign matter sticking to the O-ring, the O-ring groove or the O-ring

contact surface.

• Damage to an O-ring groove or O-ring contact surface.

• Attached strap or silica gel getting caught when closing the Case.

Perform the test after the above causes have been eliminated.

CAUTION:

If the advance test should show water leakage with normal handling, stop using the Case and contact your

dealer or an Olympus service station.

EN 10