Olympus CKX-NU Talimatlar Kılavuzu - Sayfa 26
Laboratuvar Ekipmanları Olympus CKX-NU için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Olympus CKX-NU 36 sayfaları. Reflected fluorescence system
Sayfayı Yazdır
- 1. Table of Contents
- 1. General Precautions for Observation
- 1. Using the Controls
- 2. Important
- 2. Applicable Fluorescence Objectives
- 3. Nomenclature
- 3. Centering the Mercury Burner
- 4. Controls of each Module
- 4. Switching the Filter Slider
- 4. Troubleshooting Guide
- 4. Specifications
- 4. Assembly
- 4. Assembly
- 4. U-Excitation Filter Set Ckx-Nu (Optional)
- 5. Summary of Reflected Fluorescence Observation Procedure
- 5. Proper Selection of the Power Supply Cord
1
1
2
23
2
3
Fig. 13
3
4
Fig. 14
Attaching the CKX-RFA Reflected
3
Fluorescence Illuminator
1. Gently insert the illuminator into the place from which the
dummy cover has been removed.
2. Using the Allen wrench, tighten the three screws provided
with the illuminator.
# Push the illuminator down while tightening the screws
so that the illuminator does not go upward.
}The filter slider 3 may obstruct the lower one of the screw
holes 2. Adjust the filter slider so that the open position or
the filter pocket is placed over the lower screw hole when
clamping the illuminator.
4
Attaching the Fluorescent Mirror Slider
Attach the fluorescent mirror slider, removed in
attach the washer and tighten the screw.
5
Attaching the Dust Covers
}The dust covers on the left and right are identical.
1. Align the mounting hole 2 of the dust cover 1 and the
screw hole 3 of the holding side of the slider and lightly
secure the clamping knob 4 with your hand.
2. To prevent the dust cover 1 from interfering with the fluores-
cent mirror slider and revolving nosepiece, push the dust
cover downward as well as inward and secure the clamp-
ing knob tightly using the Allen wrench.
3. Attach the dust cover on the opposite side in the same way
as above.
(Fig. 13)
2
above,
(Fig. 14)