Olympus U-RFLT50 Talimatlar Kılavuzu - Sayfa 9

Laboratuvar Ekipmanları Olympus U-RFLT50 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Olympus U-RFLT50 16 sayfaları. Power supply unit
Ayrıca Olympus U-RFLT50 için: Talimatlar Kılavuzu (36 sayfalar)

Sayfayı Yazdır
Olympus U-RFLT50 Talimatlar Kılavuzu

2-4 Connecting Cords and Cables

|
³
Fig. 6
...
ƒ
Fig. 7
1
Fig. 8
Cables and cords are vulnerable when bent or twisted. Never subject
them to excessive force as this may result in short-circuit.
Make sure the power supply unit's main switch is on "
2
before connecting cords and cables.
1. Plug the burner socket connecting cord plug @ firmly into the output
socket ² on the power supply unit.
1
Only use for U-LH50HG.
Always use the power cord provided by Olympus. If no power cord
is provided, please select the proper power cord by referring to the
section "PROPER SELECTION OF THE POWER SUPPLY CORD" at the
end of this instruction manual.
2. Connect the power cord plug ³ to the AC receptacle | on the power
supply unit.
3. Plug the power cord plug ƒ into a wall outlet ....
Connect the power cord correctly and ensure that the ground terminal
of the power supply and that of the wall outlet are properly connected.
If the equipment is not grounded, Olympus can no longer warrant
the electrical safety and performance of the equipment.
Replacing the Fuses (Fig. 8)
# Always press the main switch to "
power cord from the wall outlet before replacing the fuses.
1. Using a flat-bladed screwdriver, turn each fuse holder @ counterclockwise
and pull it out.
2. Replace the two fuses with new ones.
# Use only specified fuses. Other fuse types may result in a fire.
Applicable fuse:
U-RFLT50-100
U-RFLT50-200
T4A(H)250V (LITTELFUSE 215004). Two fuses.
T2.5A(H)250V (LITTELFUSE 21502.5). Two fuses.
U-RFLT50
(Figs. 6-8)
" (OFF)
" (OFF) and disconnect the
4