Axler CS-HCS-60A Hızlı Başlangıç Kılavuzu - Sayfa 4

Kamera Aksesuarları Axler CS-HCS-60A için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Axler CS-HCS-60A 8 sayfaları.

5. Insert the rods into their sockets in the end blocks. You may need to

work the rods a bit to fit them in. (Fig. 4)

6. Make sure the rods are completely inserted into the end blocks. Lock

them down by fastening the rod set screws until fully tightened.

7. On the underside of the slider, position the camera base so both belt

clamps are accessible.

8. On the end blocks, rotate the feet so they point outward (see Adjusting

the Feet below). This will provide easier access to the belt pulleys.

9. Select the appropriate belt for the slider's length. Fit one end of the belt

into one of the belt clamps and fully tighten the belt clamp locking knob to

secure the belt.

10. Thread the belt through the closest pulley and back through the slider,

keeping the belt taut. Make sure the belt's teeth lock into those of the

pulley, and that the belt doesn't twist. (Fig. 5)

11. Thread the belt through the other pulley and back to the other belt

clamp.

12. While pulling the belt taut, fit it into the belt clamp and fully tighten the

belt clamp locking knob.

13. With the slider right-side up, reattach the flywheel and attach the

flywheel handle (see Attaching the Flywheel Handle).

A D J U S T I N G T H E F E E T

Place the CS-HCS-60A Pro Camera Slider on a steady surface. For

enhanced artistic control over your images, you can adjust the angle and

length of the feet to manipulate the orientation of the slider and achieve

creative camera angles. The onboard bubble levels can be used to help

achieve level shots.

ANGLE

To change the angle, loosen the thumbscrew (Fig. 6), adjust the angle

(Fig. 8), and tighten the thumbscrew to lock down the new position .

LENGTH

To extend the foot, (Fig. 7) first rotate the foot to the desired length and

then hold onto the rubber foot while rotating the washer in the opposite

direction so it travels up the threaded post to secure the new position.

To retract the foot, first rotate the washer down the post so it sits firmly

against the rubber foot, and then rotate the foot in the opposite direction

so the it retracts.