Alpha-InnoTec RBE Kullanım Kılavuzu - Sayfa 5
Kontrol Ünitesi Alpha-InnoTec RBE için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Alpha-InnoTec RBE 12 sayfaları. Room control unit
Sayfayı Yazdır
Electrical connection
DANGER!
Risk of fatal electric shock!
All electrical connection work must be carried out
by qualified electricians only.
Before opening the unit, disconnect the system
from the power supply and prevent it from being
switched back on again!
WARNING!
Note and follow the relevant EN, VDE and/or local
safety regulations during installation and when car-
rying out electrical work.
Note and follow the technical connection condi-
tions of the responsible power supply company!
WARNING!
Only qualified personnel (trained heating or refrig-
eration engineer or electrician) may carry out work
on the unit and its components.
CAUTION!
A cable with a small cross-section reduces the approved
length of the connection cable. If the cable is too long the
RBE may not work!
ATTENTION
Electrical work on the room control unit may only be car-
ried out by the authorised service personnel or specialised
firms, which have been authorised by the manufacturer.
1
2
A2
RBE
* The 30 m between the heat pump (WP) control unit and the RBE are only allowed if the connection cable between the WP
control unit and the master board of the WP control is ≤ 3m.
Raumbedieneinheit
83032600bUK– Translation into English of the original German operating manual – Subject to technical change without notice.
3
4
LIN-Bus
RJ45
CONNECTING THE COMMUNICATIONS AND POWER SUPPLY
Anschluss von Kommunikation und Span-
Communication and power supply take place via the RS485 interface
nungsversorgung
attached to the heat pump control unit. The RBE must be connected to
this interface.
Die Klemme in RMU 40 wird mit Klemme X4:9–12 an
Use a flexible cable type (LiYY, EKKX) or equivalent. The required and at
der Eingangskarte (AA3) in der Wärmepumpe verbunden.
the same time maximum cable cross-section 0.5 mm².
Verwenden Sie Kabeltyp LiYY, EKKX oder gleichwertig.
Connect as shown in the following terminal diagram:
RMU 40
F1145
Technical data
Surface-mounted frame made of plastic
WxHxD (mm)
RBE dimensions WxHxD (mm)
Nominal voltage
1
2
A2
To commission or start up the RBE, follow the procedure
described on page 9.
RBE
F1245
5
Room control unit
Raumbedieneinheit
Legende:
Bezeichnung
A2
RBE
RJ45
Raumbedieneinheit RBE
max. 30 m*
-
PEP 008/2013
-
Zustand
Änderung
1
2
zu berücksichtigen.
F1145/F1245/F370/F470/F750 darf bei der Instal-
lation von RMU 40 nicht mit Spannung versorgt
werden.
Terminal
+12V GND
B
A
RMU 40
85x85x35
A
B
85x85x14
GND
+12V
3
4
12 V DC 40 mA
5
(Power supply from the heat pump)
LIN-Bus
RJ45
RJ45
6
7
RMU 40
F1245
7
DE831183
Funktion
Bedienteil
Raumbedieneinheit
24.07.2013
Achim Pfleger
Datum
Name
3
4
5
F1145
13
12
11
10
9
6
7
8
8
7
RBE
+12V
GND
B
A
8
9
RBE
8
9
10
11
12
13
Datum
24.07.2013
Bearb.
A. Pfleger
6
7
8
5