Axminster 107700 Orijinal Talimat Kılavuzu - Sayfa 15

Torna Tezgahı Axminster 107700 için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. Axminster 107700 19 sayfaları. Woodturning lathe

Lubricating the drive shaft

Over time the spindle drive on the Variomatic'

speed control assembly will need lubricating to

prevent the moving pulleys from seizing. It is

recommend to check and lubricate the shaft on

a regular basis.

1) Remove the four dome head screws holding the

head stock cover in place. Remove cover, clean the

pulley mechanism and remove any build up resin

debris. Use a push type grease gun for chainsaw

sprocket nose guide bar. Place it over the grease

nipple to the end of the motor drive shaft & pump

in grease several time until you see it emage over

spring assembly. Re-fit the cover and secure in

place.

Remove the four dome

screws holding the

cover

Grease nipple

Pump grease into the shaft serveral times, you will see

grease emerge from the spring.

2) Spray ambersil PTFE film anti-stick over the lathes

spindle shaft & Swivel mechanisum this will help to

reduce friction and to help prevent it from corroding.

Maintenance

Grease gun for chainsaw

sprocket nose guide bar

PUMP Grease into shaft