Axminster ujk 106843 Manuel - Sayfa 19

Araçlar Axminster ujk 106843 için çevrimiçi göz atın veya pdf Manuel indirin. Axminster ujk 106843 20 sayfaları. Universal dovetail jig

NB - The cutter will need to be loaded in through the

base of the router with the ⅝" guide bush already in

position, 19-20. DO NOT RELEASE THE PLUNGE FULLY

WHEN CUTTER IS FITTED, the cutter will be damaged

as it passes through the inner guide bush.

Fig 19-20

A corner dovetail rebate joint can be achieved in any

board thickness above 12mm in 2 passes using the ¾"

guide bush & dovetail cutter -

1) Attach comb B with the long groove slot at the front

of the jig, see fig 21 move both side stops to a central

position & lock in place, see fig 22.

Fig21-22

2) Mark a line ⅔ thickness of the board, see fig 23 & load

in the horizontal board. Support board gainst the left

hand side stop ensuring that the comb is sat flat on the

board, a support board with equal thickness to the cut

board may be required to support the comb when using

narrow boards, see fig 24.

Fig 23-24

Side Stop

CORNER DOVETAIL REBATES

3) Use the wider part of the set gauge to position board

edge to the centre of the comb slot, see fig 25-26.

Fig 25-26

4) Plunge the cutter down through the comb slot to set

the cutter depth to the marked pencil line, see fig 27.

Attach the magnetic extraction at the right hand end

of the support bar, see fig 28 or on a larger width board

attach the right hand side stop to the right hand end of

the jig to support the magnetic extraction. Alternatively

the router's in built extraction nozzle can be used, see fig

29-30.

Fig 27-28

Fig 29-30

Side Stop

Continues over...