Axminster H20002 Manuel - Sayfa 4

Elektrikli Alet Axminster H20002 için çevrimiçi göz atın veya pdf Manuel indirin. Axminster H20002 6 sayfaları. Fixed drill press

Partial assembly

Positioning clamp 'D'

Fig 1

Return spring

Guide rods 'B'

Steady handle

Typ. 4 Bolt Holes

'V' groove base

Insert

'V' groove

Drill mounting bridge

Return spring

Depth stop clamp 'E'

Fig 2

Housings

'V' groove

Typ. 4 countersunk

screw/bolt holes

Guide rod clamps

base

Drilling bar, tube or rod

Lay the workpiece across the 'Vee' guides in the base, clamp in position and drill. If the work

piece is liable to flex during the drilling operation, insert the 'V' grooved insert into the base to

support the work.

Drilling at Angles

Engraved mark

There are 3 set measurements marked on the guide rods that will enable you to tilt the drill

press over to 30, 45 and 60 degree angles. These marks should be set level

with the UNDERSIDE of the base.

(Other angles can be set using a bevel gauge or template. Ensure the guide rods are

firmly locked in position before carrying out drilling operations).

Tool illustration and Parts description

Fig 9

Fig 10