Axminster SIEG G1 Engineer Series Kullanıcı Kılavuzu - Sayfa 5
Elektrikli Alet Axminster SIEG G1 Engineer Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Axminster SIEG G1 Engineer Series 16 sayfaları. Powered hacksaw
Ayrıca Axminster SIEG G1 Engineer Series için: Kullanıcı Kılavuzu (16 sayfalar)
Sayfayı Yazdır
Good Working Practices/Safety
The following suggestions will enable you to observe good working
practices, keep yourself and fellow workers safe and maintain your
tools and equipment in good working order.
!
WARNING!!
Mains Powered Tools and Machines
Primary Precautions
These machines are supplied with a moulded 13 amp. Plug and 3 core power cable. Before
using the machine inspect the cable and the plug to make sure that neither are damaged. If
any damage is visible have the damaged item inspected/repaired by a suitably qualified
person. If it is necessary to replace the plug, it is preferable to use an 'unbreakable' type
that will most resist damage. Only use a 13 amp plug, and make sure the cable clamp is
tightened securely. Fuse as required. If extension leads are to be used, carry out the same
safety checks on them, and ensure that they are correctly rated to safely supply the current
that is required for your machine. Remember, most machines or tools have handles or
holding positions, the power cable is not one of them!
Work Place/Environment
The machine is not designed for use outside. Keep the machine clean; it will enable you to
more easily see any damage that may have occurred. Clean the machine with a damp
soapy cloth if needs be, do not use any solvents or cleaners, as these may cause damage
to any plastic parts or to the electrical components.
Keep the work area as uncluttered as is practical, this includes personnel as well as
material.
Under no circumstances should CHILDREN be allowed in work areas.
It is good practice to leave the machine unplugged until work is about to commence, also
make sure to unplug the machine when it is not in use, or unattended. To avoid inadvertent
'start up'; if your machine is not fitted with a NVR system, ensure the switch is always
returned to the OFF position. Once you are ready to commence work, remove any tools,
objects or items that could inadvertently get 'sucked up' by the machine (if any) and place
safely out of the way.
Re-connect the machine, ensuring the power cable is not 'snagged' or routed where it could
be tripped over as you move about the workshop, it is not too close to an unguarded heat
source or is laid over or around a sharp edge.
If the work you are carrying out is liable to generate flying grit, dust or chips, wear the
appropriate safety clothing, goggles, gloves, masks etc. If the work operation appears to be
excessively noisy, wear ear-defenders. If you wear your hair in a long style, wearing a cap,
safety helmet, hairnet, even a sweatband, will minimise the possibility of your hair being
caught up in the rotating parts of the machine, likewise, consideration should be given to
the removal of rings and wristwatches if these are liable to be a 'snag' hazard. Consideration
should also be given to non-slip footwear, etc.
General Instructions for 230v Machines...
KEEP TOOLS AND EQUIPMENT OUT
OF THE REACH OF YOUNG CHILDREN
05