Axminster Euro Twist Pen Kits Talimatlar Kılavuzu - Sayfa 4

Aksesuarlar Axminster Euro Twist Pen Kits için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Axminster Euro Twist Pen Kits 12 sayfaları.

Preparing the Bodies...

Using 16mm (5/8") Square stock; cut the blanks to the length of the brass tubes

adding 2-3mm to allow for trimming. The Pen Blank Sizing and Cutting Jig makes this process

very much easier.

Drill a 7mm diameter hole through the centre of the blank. Care must be taken not to force the

drill bit, (this may cause it to 'wander' from the centre line), and remember to back out the drill

frequently to clear the debris from the hole. If you are using a pillar drill the Quick Action Pen

Blank Vice is a very useful accessory for this task, it ensures that the blank is held upright and

firmly in position. Moreover, if the vice is clamped to the table of the drill, it will provide accurate

repeatability for all the blanks that require drilling.

When the hole is drilled, spread the adhesive randomly over the brass tube and insert the tube

into the blank using a twisting motion to ensure the glue is spread evenly between the two

surfaces. Over insert the tube into the blank by approximately 1mm giving an allowance for the

blank to be trimmed to size and the excess glue to be removed. See Fig 1.

Blank

Fig 1

Brass tube

7mm

Warning.

If you are using cyanoacrylate adhesive, exercise extreme

caution and do not allow the adhesive to come into contact with the skin.

If this happens keep the affected area from contact with any other surface,

until the glue has hardened or you can treat the area with a softening

agent similar to Zap Z-7 Debonder (Part no. 990099), and you can remove

the glue.

Zap Z-7

Debonder

Allow the adhesive to dry thoroughly.

Using the Barrel Trimmer trim the ends of the blanks squarely and neatly to the ends of the brass

tubes; this will also remove any excess glue that may have exuded from the joint. Take care not to

undercut the brass tubes.