Axminster AWDWSG Kullanıcı Kılavuzu - Sayfa 19

Öğütücü Axminster AWDWSG için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Axminster AWDWSG 20 sayfaları. 150/200mm wetstone grinder

Nut

Fig 21

Now is a good time to clean the water trough thoroughly, and check for, and correct any

signs of erosion/oxidation on the gearbox components. Fit the new stone and re-assemble

in reverse order. Take care not to over-tighten the securing screws, as damage could result

to the fixing lugs of the water trough. Replace the bung/leg and refill the trough with clean

water.

If the grindstones wear unevenly, producing crests, dips or rounded edges, they

should be dressed out using a suitable wheel dressing tool. (A selection of stone dressing

tools are available in the Axminster catalogue.)

Switch the grinder on and allow it to run for at least one minute. Rest the dressing tool on

the tool rest and advance it to the stone until it touches the maximum diameter; gently move

the dresser back and forth across the face of the stone until all irregularities have been

removed and the edges of the stone are nice and sharp.

Changing the wet grinding wheel...

Plate flange

Fig 22

This is not a procedure that can be

rushed, it must be carried out slowly

and steadily.

FREEPHONE

Dressing a stone...

PLEASE NOTE

Dressing the wheel using a

Wheel Dressing Stick or

Devil Stone

Part no. 410074

0800 371822

Grindstone

Fig 23

A X M I N S T E R

W H I T E