AXMINSTER TOOLS WORKSHOP AW1502WSG Orijinal Talimat Kılavuzu - Sayfa 11

Öğütücü AXMINSTER TOOLS WORKSHOP AW1502WSG için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. AXMINSTER TOOLS WORKSHOP AW1502WSG 17 sayfaları.

Sayfayı Yazdır

DRESSING THE STONE/CHANGING THE LIGHT BULB

CONNECT THE GRINDER

TO THE MAINS SUPPLY.

Switch on the grinder, wait until it reaches full speed

and leave the machine running for at least one minute

before carrying out any work. Apply a work piece and

check that the spark guard is correctly positioned and

that the tool rest is securely fixed. Switch off and wait

until the grinder comes to a complete stop.

DISCONNECT THE GRINDER

FROM THE MAINS SUPPLY.

After a period of time uneven wear on the stones

including crests dips or rounded edges will appear.

They will need to be dressed out using a suitable wheel

dressing stick. See our website and in our catalogue for

details, see fig 10-11.

Fig 10-11

Code 410074

Wheel Dressing Stick for coarse carborundum

and dressing worn or unbalanced wheels.

Code 410057

Diamond Dressing Block useful for dressing across

the width of the grinding wheels or to produce flatter

surfaces than single point dressers.

CONNECT THE GRINDER

TO THE MAINS SUPPLY.

Switch the grinder on and allow it to run for at least

one minute. Rest the dressing tool on the tool rest and

advance it to the stone until it touches the maximum

diameter; gently move the dresser back and forth

across the face of the stone until all irregularities have

been removed and the edges of the stone are nice and

sharp, see fig 12.

Changing the Light Bulb

The flexible light has a 12V 0.36W screw threaded LED

bulb. Unscrew the blown bulb and replace.

Fig 12

Step 13-14